Design review example设计评审实例
A two-piece electronics enclosure由上盖和底壳组成的电子外壳
For a lid and base that close around a circuit board, the assembly drawing is as useful as the individual part files. Here are three details worth settling before the mold is cut.当上盖和底壳需要合拢并固定电路板时,除了单件图纸,还需要装配图。以下三处细节建议在开模前确认。
| Part feature零件特征 | Before cutting steel开模前确认 | What to check on samples样件检验要点 |
| Lid and base上盖与底壳 | Before cutting steel开模前确认Mark the visible faces and specify the gap and step allowed at the seam.标明外观面,并注明接缝处允许的间隙和段差。 | Sample check样件检验Fasten the assembled housing and check the seam at the corners as well as along each edge.将上下壳装配并紧固,检查四角及各边接缝处的间隙和段差。 |
| Screw bosses螺丝柱 | Before cutting steel开模前确认Identify the screw or insert and the outside face directly behind each boss.注明所用螺钉或螺纹嵌件的规格,并标出每个螺丝柱背面对应的外观面。 | Sample check样件检验Fit the specified fastener and inspect the outside wall for a visible depression, or sink mark.装入指定的紧固件,检查螺丝柱对应的外壁是否出现可见缩痕。 |
| Connector opening连接器开口 | Before cutting steel开模前确认Locate the cutout from the board mounting points. Include the mating plug in the clearance check.以电路板安装孔为基准确定开口位置,核对配套插头所需的插拔空间。 | Sample check样件检验Install the board, close the cover, and confirm that the actual plug seats fully.装好电路板并合上外壳,用实际配套的插头试插,确认能完全插到位。 |
Sample approval样件确认与封样
Identify the drawing revision and resin grade used for the trial. Record any change against the sample it affects. Once fit, finish, and critical dimensions are accepted, keep an approved sample as the reference for repeat orders.记录试模所用的图纸版本和材料牌号,各项修改应对应到具体样件。装配、外观和关键尺寸确认合格后,保留签样,作为后续批次的验收依据。